Z table limit switch


(Douglas Scott) #1

Machine: K40

Board: Cohesion 3d Laser
Firmware: _Smoothie

Problem/ Question: Uncertain where to plug in the limit switch for the Z table I’m installing. Any help would be appreciated!

Thanks,
Doug Scott


(Brian Bell) #2


Z min and z max

If the endstops are mechanical use sig and gnd.


#3

Yes, Z Min OR Z Max depending on where your switch is located. Then you need to set it correctly in the config file as well.


(Douglas Scott) #4

Thank you! I appreciate the help!


closed #5