Z table help!

Machine: _K40

Board: LaserBoard

Firmware: “I have a new board and I’m using whatever it came with”

Problem/ Question:
Hey guys My issue is I hooked up my lightobjects Z table to my cohesion3d laserboard and enabled the z axis on light burn, but not getting any movement. I wired it up based on the diagram below… I changed the configuration files following the steps suggestrd again below. I swapped the z and y axis connectors and with y moved but still nothing on the z table even with the belt completely loose no movement whatsoever. Any help would be appreciated!

Hi,
just a suggestion. As you have not used a different stepper driver ic I would like you to check your Motor connections. Do you have the make of the stepper motor an had a look at its Datasheet.
Perhaps B- is Orange, B+ Black, A- Yellow and A+ Red?

Giovanny, did you test another stepper motor and determine the one that came with the Z table was faulty?

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.