Machine: K40 with Lihuiyu Studio Labs
Board: Cohesion3D Laser board
Firmware: _Smoothie "I have a new board with a Graphic LCD control panel
Problem/ Question: _I received the control board and was excited to install it and start cutting.
The wiring was extremely simple. I just unplugged the board that came with the K40 and replaced with the Cohesion3D Laser board without a hitch. I inserted the SD card that came with the board. When I applied power, the lights flashed as described in the install instructions. New COM port appeared in device manager and is connected.
The only problem is the lack of any new mass storage devices in “My Computer” . I see my standard drives (A, C, D, E, K, CD drive V, CD Drive W, X,Z and mapped drive F.
Question: How do I access the config fiile on the SD Card?
The LCD Display is otherwise working and I have inserted a new SD card in it but i am also unable to access that SD card. What is the SD card on the LCD for and how do I access it?
I am able to run LightBurn and I am engraving away. This card is so smooth that I almost have to look in the machine to make sure it is running.
Last question: Where do I find a description for the pinout and jumper configuration for the board?