USB panel mount

Hello Guys:

I’m about to use the C3d board on a Co2 laser engraver DIY project “frankenrotor” and want to know if this 12 inch extension will cause any comm issues or it is not recommended, that is the way I have my other DSP controllers setup

thanks

I don’t think a foot will cause problems. Is it shielded? 12" should be ok, but as with anything, EMI can be ruthless.

This is just my personal thoughts, I had considered putting my mini in a metal project box, drilling some holes and placing a micro fan.

installed just now will see when I finish covering this thing to test it, are you getting some juice out if that laser tube or it already expired

?

It is actually firing and the end hasn’t fallen off.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.