Sttepper motor

Hello! I have some questions. Where in firmware configuration can I disable stepper motor break/blockage. I’m currently using driver for motor nema 23 which oftens gets warmer than it should be, otherwise it’s working as intended. I already lowered tension and current to 2.7A on power supply and current on stepper motor is 3A. Motor nema17 is connected directly on control panel and is also on the same constant tension but it doesn’t warm up as nema23 motor. Are there any solutions for this?

Hi Tomaz, I’m having trouble understanding what you are asking for.

Would you be able to provide some photos of your setup and perhaps provide a clearer explanation of what your goal is?

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.