Stepper Driver swap A4988 to TMC2208

Machine: k40

Board: Mini

Firmware: _Smoothie

Problem/ Question: Looking to swap the my old A4988 drivers in my c3dmini for some TMC2208 drivers. These are some spares after swapping the TMC2208s for higher power TMC5160 in our 3dprinter. I have read it is possible; any steps or a guide to do so?

Yes, it is possible. Use TMC2208 in dumb mode. There may be some previous conversation about it on the forum. There is no documentation on the subject from us.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.