Skipping steps

Machine: K40

Board: LaserBoard

Firmware: “I have a new board and I’m using whatever it came with”

Problem/ Question: I can not get the Camera Alignment to Print in light burn its all over the place, I just upgraded to a Cohesion and add a Light burn camera. I have replaced all the bearings and belts and any other print even at a much higher speed comes out great. In the Cohesion config I have cut the acceleration in half and set the amperage of the steppers to spec I am running out of ideas

Did you provide those pictures? We need pictures to understand your setup!

I got it figured out the steps where being skipped during travel and the max travel speed is was set at 24000 I turned it down to 2400 and it is now working fine.