Rotary not returning to left off position when scanning

Machine: Blue and white K40 300x200 bed

Board: Cohesion3D laserboard

Firmware: _Smoothie or GRBL-LPC? "Running Smoothieware

Problem/ Question: When scanning on to tumblers with file, the image is left with uncut lines. While doing this logo, the software seems to break up the image into smaller segments to scan. When it returns to finish the engrave, where it left off, it doesn’t completely scan, leaving missed areas.
Is this rotary settings or software settings incorrect? IMG_20190522_210602112|375x500

Your images did not upload properly, please edit your post to try again, verify that you see them in the preview window, then reply to let me know they are in.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.