Problem with Laser Power Output

Machine: Chinese 60 W

Board: Laserboard

Firmware: Smoothie

Problem/ Question: I’m having problems to control the power throw Light burn. I run a test and all the power outputs look the same.
I think it is not using all the power of the machine. I can only cut until 3 mm ply. More than that and I can’t cut with one pass. It doesn’t seem normal to me.
Other problem that occurs frequently is the machine skippes and the images becomes distorted.
I tried to put photos of my setup and the tests to show but I can’t because I’m a new user.
Can anyone help me with that. I already read some threads and o saw that the max power on the card file is on 1 and pen 200.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.