Pinout Cohesion3D LaserBoard GLCD Adapter

Board Configuration and Setup
#1

Can anyone tell me the pinout of the GLCD adapter. (Cohesion3D LaserBoard)
Thanks a lot for your effort.
Nils

#2

Perhaps this link may help - https://reprap.org/wiki/RepRapDiscount_Full_Graphic_Smart_Controller

#3

Hello Alan,
thank you very much for your answer. But I need the pinouts on the Cohesion3D LaserBoard. Or the wiring of the Cohesion3D GLCD adapter.
Best regards Nils

#4

Hi Nils,
Do you have a Cohesion3D Mini or the newer Cohesion3D LaserBoard?
Alan

#5

Hallo Alan,

i have newer Cohesion3D LaserBoard.

Nils

#6

View on the pins. USB connector on the right. I could already measure these pins:

5V | GND
? | SCK
? | ?
? | ?
? | ?
? | ?

Nils

#7

Take a look at this post Laserboard GLCD adapter pinout
May help sending a request for further help to vmaxuser
Hope that helps, if not hope "Cohesion Support " come back to life!
Good luck, Alan

#8

Hello Alan,
thank you very much. :grinning:
Nils

#9

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.