Pinout Cohesion3D LaserBoard GLCD Adapter

Can anyone tell me the pinout of the GLCD adapter. (Cohesion3D LaserBoard)
Thanks a lot for your effort.
Nils

Perhaps this link may help - https://reprap.org/wiki/RepRapDiscount_Full_Graphic_Smart_Controller

Hello Alan,
thank you very much for your answer. But I need the pinouts on the Cohesion3D LaserBoard. Or the wiring of the Cohesion3D GLCD adapter.
Best regards Nils

Hi Nils,
Do you have a Cohesion3D Mini or the newer Cohesion3D LaserBoard?
Alan

Hallo Alan,

i have newer Cohesion3D LaserBoard.

Nils

View on the pins. USB connector on the right. I could already measure these pins:

5V | GND
? | SCK
? | ?
? | ?
? | ?
? | ?

Nils

Take a look at this post Laserboard GLCD adapter pinout
May help sending a request for further help to vmaxuser
Hope that helps, if not hope "Cohesion Support " come back to life!
Good luck, Alan

Hello Alan,
thank you very much. :grinning:
Nils