Ortur Rotary tool

Hi there,

I have an Ortur Laser Master 2 rotary tool. Can I use it with this board?

Thanks

This one? https://www.amazon.com/derp/dp/B08CBV2B6N

If so, it looks like it will work since it just has a NEMA17 size stepper motor. You’ll need to calibrate some values in the config file but it shouldn’t be too difficult.

Yes, this is the one I have.

Thanks

Yes, connect it to the ‘A’ stepper output and it will work fine with Lightburn. As @loather points out, you will need to update some values in the config file. IIRC, there is a page on the Cohesion website related to setting up a rotary.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.