Origin not setting

Machine: k40

Board: cohesion3d

Firmware: whatever it came with

Software: lightburn

Problem/ Question: Can’t set origin, so I have something I want to cut out from an a4 sheet, super close to edges, if I run the outline test from origin gantry gets to top and grinds because there’s not enough space.

I have a few cm below the origin to spare so I moved the head to there and selected set origin but when I homed and pressed to go back to origin it went back to the old one, have tried several times but it will not accept the new origin, any help appreciated, if you need pics, tell me what of

Cheers

Ben

–SOLVED–

found my answer in this post

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.