Official LightBurn Camera Installation Instructions

A full video install guide is available here for the Official LightBurn Camera:

Here is the getting started part:

  1. Plug the cable small end into the camera module (it only goes in one way, don’t force it) and the USB end into the computer.

  2. Enable Camera Control by right clicking on the Cuts bar at the top and clicking Camera Control to enable it.

  3. In the Camera: dropdown, LightBurn Camera should appear as an entry. Select it.
    You should see the camera preview now.

  4. Figure out a way to mount the camera in your laser.

  5. Do the calibrations - watch the video for this and onward.

A few tips: On Windows 8 and 10, the camera should be recognized by your computer automatically.
On Windows 7, you may need to install a driver and/ or run Windows Update to get all the latest updates on your computer.

The driver for Windows 7: