LPSU power taps available?

K40/C3D/Smoothie

From the board layout, it appears that the 5v and 12v power from the PSU are not used. I would like to cut the 5v wire and use it for lighting 5v illuminating push buttons.

I just want to confirm that removing either of these voltages from the power plug will not affect the operation of the c3D?

Ray?

Thanks

No, the 5V and 12/24V rails on the LPSU are not internally connected to the laserboard at all. The laserboard and its stepper drivers get all the power necessary from the power brick that shipped with the unit.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.