Machine is custom frame w/ Endurance labs 10w head.
Board is a C3D Laserboard
Firmware: _Smoothie
Problem/ Question: I recently installed an X minimum and a Y maximum end stop switches. The machine homes correctly. The issue is that when I run a job using Absolute Coordinates the laser hits the Y max side of the frame while trying to get to the job position. If I place the job near the bottom of the work area (low X and Y coordinates) then the machine starts the job VERY close to the top of the y axis.
My X axis is 35.5 and my Y axis is 27.
I appreciate any help. Thanks.
