K40 X and Y axis scale factor edit

Machine: K40

Board: Cohesion 3D

Firmware: _Smoothie

Problem/ Question:
Is it possible to edit X and Y scale factor like we did on k40 Whisperer software?
I need to do that because if i cut a 10cm square the X dimension would not be 10cm. it will larger. So i will have a rectangle and not a square.

Thanks for the help in advance.

You should first try jogging the machine and measuring how much it moves in each axis. If this is off, it is possible to adjust the steps per mm in the board’s config file on the memory card.

Our default values should be correct for the K40. Please try the jogging 100mm and measuring first.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.