K40 laser not firing when trying to engrave

Machine: K40

Board: cohesion

Firmware: smoothie

Problem/ Question: well 2 issues

  1. Homing the laser it goes to the back left corner. I use lightburn. When I hit origin it goes to the front left corner. Are they both supposed to be in the same spot?
  2. I tried to engrave 3mm wood and the laser did not seem to fire. I will provide video but unsure how to upload

for my ten-high 50w laser this was correct. bottom left is origin aka 0,0. home switches in top left.

A post was merged into an existing topic: K40 Upgraded board to Cohesion, Y axis is not moving and not homing

@Colten oh ok! Ty!