Issue with homeing/cutting area

Machine: K40
Board: Cohesion3D LaserBoard

Firmware: I have a new board and I’m using whatever it came with

Problem/ Question: When I home my Laser, it homes fine, but when I’m about to cut, and I frame the cut area I have issues. The frame area doesn’t hits the endstops and not the area it should.

Video of issue:

I have had this happen when I had “current position” mode set in LightBurn but should have been using “absolute coordinates”.

But first, please show pictures of your machine, board, and wiring, and a full screenshot of your LightBurn window so that I can look for any obvious issues there and better understand what your actual problem is. I see the head crashing against the Y rear in the video, but have no context of what the job is or what’s supposed to be happening.

Finally, please make sure of this:The origin really is the front left. I know the homing switches are in the rear left. You're not special

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.