Installing C3D board with power supply. K40 laser

Machine:K40 M2 Nano Board

Board:C3D

Firmware: “I have a new board and I’m using whatever it came with”

Problem/ Question:
Just got my C3D board with power supply preparing to do the swap over, I’m pretty confident with the directions with one exception. If I’m removing the old power supply that it came with totally where does the Orange wire that is hardwired into the back of it go? I’ve looked high and low on the board here and have not found an answer. I’m hoping you kind folks can help.

Wire at the back of the original power supply that goes to the tube.

Thank you very much in advance, I appreciate your time.

Julie :slight_smile:

Got my question answered and it installed. So far so good, thanks!

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.