HPC LS3020 stepper config

Machine: HPC LS3020
Board: Cohesion3D
Firmware: Smoothie

Problem/ Question: I have installed my Cohesion board into my LS3020 i tried speeding up speeding down and more to get the correct configuration, but i really don’t know how to config speed, power, acceleration or resistance to get the best out of the laser cutter and not damaging the belt and

I have attached the config information of the stepper drivers

Hi Mike,

Welcome to the forum!

We recommend starting here: Configuration Adjustment Guide

This model has a 0.9° step angle, which is pretty common for K40 machines. The default configuration for your steps should be close to what you need, but you can use the tips in the article above to dial in your settings.

We also saw your email about homing. Did you get that sorted or do you still need info on setting it up?

Let us know if you have any questions.