Home resets bed positioning

Machine: k40 using lightburn

Board: cohesion3d

Firmware: _Smoothie

Problem/ Question: What gives. Every time on my start up procedure my machine homes in the top left corner if I set my laser position and click to the top left corner my machine jumps a couple times this allows me to get my full working area. If I do not position my laser to the top left corner I do not get my full working size of my bed. I have to do this every time I turn on or home my machine

Hi Patrick,

This sounds like the same thing you were asking about the last time you posted a while ago.

If that is the case, please consult this article:

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.