Help with Homing on my K40 12x24 Conversion

Machine: K40 12x24 Conversion
Board: Cohesion3D Laserboard
Firmware: N/a

Problem/ Question: I just rebuilt a regular K40 stock to the K40 12x24 Conversion. I can move the axis connected to Lightburn but Homing is not working. Using a mechanical endstop with 3 wires. When pressed the light comes up on the end stop. Place the X and Y axis endstop on 0,0 Origin and adjusted connected them both to Min on the board. Included my config.txt and some photos. Any help would be appreciated.

Edit: I solved my own issue. Read some more articles and figured out my all my endstops were engaged using M119 in Lightburn.

Mod_config.txt (28.4 KB)

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.