Help! End stop wires pulled from mini molex connector

Machine: preened k40

Board: c3d laserboard

Firmware: not sure havent finished fixing/ installing

As I was installing my laser board, all 4 pins pulled out of my 5 pin end stop connector. Does anyone know how they go back in order? Please see attached pic.

They are known for doing that :expressionless:

Better off to get a multimeter in continuity mode, and identify the pairs that correspond to each switch. Then you can use better connectors like the ones on our site to put them to the nice row of individual endstop connectors on the bottom of the board.

And it looks like your order contained a set of the crimp connectors! See, they can be useful for situations like this!

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.