Engraving problem

Machine: k40

Board: LaserBoard

Firmware: “I have a new board and I’m using whatever it came with”

Problem/ Question: when I increase the speed the square im engraving gets smaller in width. 50mms is the actual size it should be, 6mm. 125 mms is 3mm wide, (see picture). How can I change this.

Did you provide those pictures? We need pictures to understand your setup!

Can’t upload pictures sorry.

Hi Jason,

Welcome to the forum! I have upgraded your trust level so that you can now upload photos.

Hi Jason,

What kind of machine do you have and what is the work area size? Out of curiosity, do you have or use a rotary? Check to ensure that it is not enabled in LightBurn under Tools > Rotary Setup.

If not, please provide clear pictures of your machine, control panel, work area, and wiring.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.