Machine: K40
Board: Cohesion3D Mini
Firmware: Smoothie -I have a board and I’m using whatever it came with
Problem/ Question:
Installed new limit switches and M119 shows
X:1 no matter what
I have swapped the limit switches at the board and same result (limits switches, cable, connections are good) I even tried both switches on Z and it opens and closes correctly. I used a jumper wire to jump the pins on the back of the board : ground to signal. Y works, However X stays X:1 or closed no matter what. Any help is much appreciated, not sure if this is a board or software/firmware problem.