Machine: stock Full Spectrum MLE-40 with their 2 board setup
Board: LaserBoard
Firmware: I have a new board and I’m using whatever it came with
Problem/ Question: I didn’t order the “connector pack” as it was “out of stock.” Can give me some part numbers that I will need in order to complete my installation?
The endstops are Molex KK 3 pin for the individual breakouts, the combined endstop connector is a JST XH 2.54mm 5 pin, the X/Y motors are JST XH 2.54mm 4 pin, and the external stepper connectors are JST PH 2.0mm 6 pin. The Z and A motors are bare headers and will take an XH 4 pin just fine or you can crimp on a DuPont 2.54mm connector instead. You can find them all on amazon.
Thanks. Ordered.
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.