Config file help for bed size. MLE-40

Machine: Full Spectrum MLE-40
Board: (LaserBoard)

Firmware: I have a new board and I’m using whatever it came with

Problem/ Question: I can not seem to plug the correct settings into my config file to hold a correct bed size.
Not sure if or what has been upgraded on this machine because I bought it used. I’ve upgraded to the Cohesion 3D board but I’m not smart enough to adjust settings.

You’re in luck - the documentation section of the main website has a guide for setting bed size in LightBurn and the machine’s config file:

The Knowledge Base has a lot of good articles for setting up your machine. I encourage you to give it a once-over as many common installation issues can be solved with the articles there:

Good luck!

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.