Cohesion board limits

Are the limits in Cohesion 3D soft or hard limits (software configurable or limit SWITCH)? I had a CNC mill that had both. The software ones would slow the mill down, the switches were hard shutdown to prevent damage.

It’s configurable in software. They’re by default set up for homing switch operation (soft limit) but they can be configured to be hard limits as well. Note that if you decide to do hard limits you’ll need switches at both ends of each axis in order for it to work properly.

Okay thanks. I have the switches in place ready to be wired. Good to have soft limits too though.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.