Chuck installation

When I purchase the 2 units they came with 2 rollers and a stepper motor wired for each.
The cups slide down and it moves so I put some elastic to stop it all good.

What do you do when it has a handle? I went to Omtech but the connector is not the same mine in a 4 pin white flat block I plug into the board the new one is with a chuck ROTARY AXIS WITH JAW CHUCK FOR 50W AND UP CO2 LASER ENGRAVER CUTTING MACHINE can it be hooked to the board or how do I do it?

If there is anyone that can or wants to FaceTime to give some instructions would be great.

Thank you in advance.

Thank you in advance

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.