Can the board be pre wired for plug'n'play?

Hello,
I’ve actually purchased a cohesion3d from a european reseller but after 4 months of waiting it has never been sent out.
So I got a refund and decided to go straight to the source :slight_smile:

Trouble is, while I have loads of good experience with my k40, i’m not very good with electronics/electrics.
Is it possible for the board to be wired based on a picture of my m2nano?

Also, I do not plan on installing z table or rotary attachment, but i would like to replace my existing stepper motors to increase engraving speed - can you advise on how many External Stepper Drivers and what type of nema17 motors should I get?

I already purchased lightburn and your camera and am itching to be able to use it! :smiley:

Many thanks for your time and patience,
Marcin
Awesome Wood Art
Ireland

There is no “custom cabling” needed to install the board in a standard M2Nano setup.

Please compare your setup to our installation instructions:

1 Like

Excellent, thank you very much for your reply!
Any chance I could get clarification on the stepper motors?

“Also, I do not plan on installing z table or rotary attachment, but i would like to replace my existing stepper motors to increase engraving speed - can you advise on how many External Stepper Drivers and what type of nema17 motors should I get?”

Thanks again,
Marcin

My advice: DO NOT replace the stock stepper motors.

1 Like

Perfect, thank you very much for your help.
I’ve just placed my order for the board and cant wait for it to arrive.
Have a great day!