Camera Installation

Machine: k40 with Cohision 3D
Board:Laserboard

Firmware: _Smoothie
Problem/ Question: Just purchased camera and receipt tells me to go to a web address to get instructions for install. The address is not valid
need help on installing camera

A full video install guide is available here: https://www.youtube.com/watch?v=ONnmCaoUkLQ

Here is the getting started part:

  1. Plug the cable small end into the camera module (it only goes in one way, don’t force it) and the USB end into the computer.

  2. Enable Camera Control by right clicking on the Cuts bar at the top and clicking Camera Control to enable it.

  3. In the Camera: dropdown, LightBurn Camera should appear as an entry. Select it.
    You should see the camera preview now.

  4. Figure out a way to mount the camera in your laser.

  5. Do the calibrations - watch the video for this.