C3D board power supply and chattering steppers

Board Configuration and Setup
#1

Continuing the discussion from C3D board power supply:

I have replaced the C3D power supply with the one recommended. The laser test fires fine from the test fire button on the laser but when the power is turned on to the control board the the stepper motor for the x-axis just chatters, does not move, and and the laser shows disconnected in lightburn. Looking for some help on next steps to correct the issue. The laser used to work fine until I moved. Now that I have moved and replaced the power supply to the C3D board I’m having issues
Thank you!!

#2

Double check all the internal wiring and see if something got messed up in transit. That power supply is the same one included with the Laserboard.

#3

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.