Hardware Installation


No laser fire. Possible wiring issue [Hardware Installation] (3)
Main power supply [Hardware Installation] (4)
Connector question [Hardware Installation] (4)
Nema 17 motors install [Hardware Installation] (7)
5 volt out [Hardware Installation] (3)
Air assist pins, back EMF safe? [Hardware Installation] (4)
Limit switchs [Hardware Installation] (5)
Micro SD to SD Card Adapter on Mini Board [Hardware Installation] (7)
End stop pin config [Hardware Installation] (4)
Lcd controller install [Hardware Installation] (5)
Cohesion3d mini no longer responding to commands from lightburn [Hardware Installation] (10)
Z-axis probe [Hardware Installation] (3)
Glcd with laserbord [Hardware Installation] (3)
L4 light not coming on, Lightburn freezing [Hardware Installation] (12)
X and y axis moving but laser not firing [Hardware Installation] (15)
6090 wiring help please [Hardware Installation] (8)
Drive strength on Z axis [Hardware Installation] (4)
Is there detailed install instructions for lightobject z table to laserboard? [Hardware Installation] (5)
Z table wiring Laserboard [Hardware Installation] (16)
Want to replace a stepper motor, how powerful can I get before needing a stepper driver? [Hardware Installation] (10)
Laser board and air assist ok K40 [Hardware Installation] (8)
How to connect laser iode 3-5 v to cohesion3d? [Hardware Installation] (4)
Confused about connector power to cohesionboard ( 2 ) [Hardware Installation] (24)
Psu connectors k40 [Hardware Installation] (5)
Do I need to unplug anything from my LPSU when installing Laser Board [Hardware Installation] (3)
Installing mechanical endstops [Hardware Installation] (8)
Dual Y axis steppers C3D Mini [Hardware Installation] (9)
Chinese TS 4060 ( 2 ) [Hardware Installation] (23)
Ethernet adapter for Cohesion3d mini ( 2 ) [Hardware Installation] (22)
Laserboard 24V Alternate Pwr Connection [Hardware Installation] (3)